People who often use hydraulic baler/Hydraulic Baling Press will find that sometimes the hydraulic baler has insufficient pressure, so what are the specific reasons for the insufficient pressure of the hydraulic Plastic baler/Hydraulic Baling Press?
1. The temperature of the oil in the oil cylinder of the hydraulic baler/Plastic Baler Machine is too high and the viscosity is decreased, which increases the leakage, or the piston and piston rod are stuck due to excessive impurities, and measures such as heat dissipation and temperature reduction should be taken to replace the oil.
2. The sealing ring at the end cover of the hydraulic baler cylinder is too tight or too loose. Adjust the sealing ring to have proper tightness to ensure that the piston rod can be pulled back and forth steadily by hand without leakage.
3. The coaxiality of the piston and the piston rod is not good, so it should be corrected and adjusted.
4. If the piston fitting clearance is too large or the sealing device is damaged, causing internal leakage, the fitting clearance should be reduced and the seal should be replaced.
5. The matching clearance of the piston is too small, the sealing is too tight, and the movement resistance is increased. The matching clearance should be increased, and the tightness of the seal should be adjusted.
6. The piston rod of the hydraulic Plastic baler/Plastic Baler Machine is bent, causing severe friction, and the piston rod should be straightened.
NICKBALER is equipped with a professional after-sales service team. When there is a problem with the hydraulic Plastic baler equipment, you can communicate with us.